Cisco Systems EHWIC1GESFPCU manual Additional References, Examples

Additional References

	Command or Action	Purpose
Step 4	interface type slot/subslot/port number	Selects an interface to configure.
	Example:
	Router(config)# interface ethernet 0/3/0
Step 5	media-type sfp	Changes media type to SFP.
	Example:
	Router(config-if)# media-type sfp
Step 6	speed value	Configures the speed of the interface.
		Note For 100BASE SFPs, configure the
	Example:	speed to 100 Mbps only. Similarly,
	Router(config-if)# speed 100	for 1000BASE SFPs, configure
		the speed to 1000 Mbps only.
Step 7	shutdown	Disables the interface, changing its state
		from administratively UP to
	Example:	administratively DOWN.
	Router(config-if)# shutdown
Step 8	no shutdown	Enables the interface, changing its state
		from administratively DOWN to
	Example:	administratively UP.
	Router(config-if)# no shutdown
Step 9	exit	Exits the configuration mode and returns
		the global configuration mode.
	Example:
	Router(config-if)# exit
	Router(config)#

Examples

This example shows how to configure a third-party SFP on a Cisco ISR G2 Series Router:

Router# configure terminal

Router(config-if)# service unsupported-transceiver

Router(config)# interface ethernet 0/3/0

Router(config-if)# media-type sfp

Router(config-if)# speed 100

Router(config-if)# shutdown

Router(config-if)# no shutdown

Router(config-if)# exit

Router(config)# exit

Additional References

The following sections provide references related to EHWIC 1 GE-SFP-CU.

Configuring Gigabit Ethernet Enhanced High-Speed WAN Interface Cards

OL-24318-02 15