Cisco Systems WS-X6066-SLB-APC manual Clearing the EMI Gasket in a Horizontal Slot Chassis

Installing the CSM

Figure 3 Clearing the EMI Gasket in a Horizontal Slot Chassis

	WS-X6K-SUP2-2GE
	1	CONSOLE
		PORT
	CONSOLE	MODE
	SUPERVISOR2
	WS-X6K-SUP2-2GE
	2	CONSOLE
		PORT
	CONSOLE	MODE
	SUPERVISOR2
	3
Press down
	4
FAN	WS-X6224
STATUS	5
	24 PORT 100FX

6

	Switch	Load
	100%
		PORT 1	PORT 2
PCMCIA	EJECT
	1%
	Switch	Load
	100%
		PORT 1	PORT 2
PCMCIA	EJECT
	1%

Press down

SELECT

NEXT

3

4 4

	WS-C6500-SFM
5	5
	SWITCH
	FABIRD MDL
6	6

S
TU	E
TA	TIV
S	AC

1 mm Gap between the module EMI gasket and the module above it

58570

c.Using the thumb and forefinger of each hand, grasp the two ejector levers and press down to create a small (0.040 inch [1 mm]) gap between the modules EMI gasket and the module above it. (See Figure 3.)

Caution Pressing down too firmly on the levers will bend and damage them.

d.While pressing down, simultaneously close the left and right ejector levers to fully seat the supervisor engine or module in the backplane connector. The ejector levers are fully closed when they are flush with the module faceplate. (See Figure 4.)

Catalyst 6500 Series Switch Content Switching Module Installation Note

16 78-15751-04