Cisco Systems WS-X6066-SLB-APC manual Verifying the Installation, Using the CLI

Verifying the Installation

Figure 7 Ejector Lever Closure in a Vertical Slot Chassis

FAN

STATUS

24 PORT 100FX

WS-X6224

STATUS

ACTIVE

N	SE
EXT	LE
	CT

SU PE RV ISO R2

ST
ATU
S	S
YST
CO	EM
NS
P	OLE
WR
	MG
RESET
	MT
CON
SO
LE
CO
MODE PORT NSOLE
PC
MC
IA
EJE
CT
1%	100 % S
	witch
	Lo
	ad
	POR
	T1
	POR
	T2

WS -X 6K -S UP 2-2 GE

SUPERVISOR2

ST
ATU
S	S
YST
CO	EM
NS
P OLE
WR
RE	MG
	MT
SET
CONSOLE
MODE PORT CONSOLE
PCMCIA
EJECT
1%	100%
	Switch
	Load
	PORT1
	PORT 2

WS-X6K -SUP2 -2GE

63587

All ejector levers flush with module faceplate

e.Tighten the two captive installation screws on the module.

Note Make sure that the ejector levers are fully closed before tightening the captive installation screws.

This completes the CSM installation procedure.

Verifying the Installation

When you install the CSM into the Catalyst 6500 series switch, the module goes through a startup sequence that requires no intervention. At the successful conclusion of the startup sequence, the green Status LED will light and remain on. If the Status LED does not show green, or if it shows a different color, refer to Table 1 on page 8 to determine the modules status.

Using the CLI

The software interface for the module is the Cisco IOS and the Catalyst operating system command-line interface accessed through a Telnet connection to the switch or through the switch console interface. Refer to the Catalyst 6500 Series Switch Cisco IOS Software Configuration Guide and the Catalyst 6500 Series Switch Software Configuration Guide for details.

Catalyst 6500 Series Switch Content Switching Module Installation Note

20 78-15751-04