Cisco Systems Catalyst 3550 warranty About this Guide, Taking Out What You Need

Page 2

1About this Guide

This guide provides instructions on how to use Express Setup to initially configure your Catalyst switch. Also covered are switch management options, basic rack-mounting procedures, port and module connections, power connection procedures for both AC- and DC-powered switches, and troubleshooting help.

For additional installation and configuration information, and technical specifications, refer to the Catalyst 3550 documentation on Cisco.com. For system requirements, important notes, limitations, open and resolved bugs, and last-minute documentation updates, see the release notes, also on Cisco.com.

When using the online publications, refer to the documents that match the Cisco IOS software version running on the switch. The software version is on the Cisco IOS label on the switch rear panel.

You can order printed copies of the manuals from the Cisco.com sites and from the telephone numbers listed in the “Obtaining Documentation” section on page 23.

For translations of the warnings that appear in this publication, refer to the Regulatory Compliance and Safety Information for the Catalyst 3550 Multilayer Switch that accompanies this guide.

2Taking Out What You Need

Follow these steps:

1.Unpack and remove the switch and the accessory kit from the shipping box.

2.Return the packing material to the shipping container, and save it for future use.

3.Verify that you have received the items shown on page 3. If any item is missing or damaged, contact your Cisco representative or reseller for instructions. Some switch models might include additional items that are not shown on page 3.

Equipment That You Supply to Run Express Setup

You need to supply this equipment to run Express Setup:

PC

Ethernet (Category 5) straight-through cable (as shown)

2

Image 2
Contents Catalyst 3550 Multilayer Switch Getting Started Guide Taking Out What You Need Equipment That You Supply to Run Express SetupAbout this Guide Shipping Box Contents Running Express Setup DHCP-enabled PC Page Refreshing the PC IP Address Managing the SwitchUsing the Device Manager Other Management Options Command-Line InterfaceDownloading Cisco Network Assistant Before you Begin Rack-MountingEquipment That You Supply Installation Warning Statements Statement Attaching the Brackets Catalyst Rack-Mount the Switch Connect to the Switch Ports Connect to 10/100 and 10/100/1000 PortsConnect to 100BASE-FX Ports Connecting to DC Power Ground the SwitchWiring the DC Input Power Source Return Troubleshooting Express Setup Case of DifficultyResetting the Switch Accessing Help OnlineFor More Information Ordering Documentation Obtaining DocumentationCisco.com Documentation FeedbackObtaining Technical Assistance Cisco Technical Support WebsiteSubmitting a Service Request Definitions of Service Request SeverityObtaining Additional Publications and Information Cisco Limited Lifetime Hardware Warranty Terms Duration of Hardware Warranty Page Page Page USA