Cisco Systems Catalyst 3550 warranty Connecting to DC Power, Ground the Switch

After you connect to the switch port, the port LED turns amber while the switch establishes a link. This process takes about 30 seconds, and then the LED turns green when the switch and the target device have an established link. If the LED is off, the target device might not be turned on, there might be a cable problem, or there might be a problem with the adapter installed in the target device. See the “In Case of Difficulty” section on page 20 for information about online assistance.

6Connecting to DC Power

To connect the Catalyst 3550-24-DC switch to a DC-input power source, follow the steps in this section.

Equipment That You Supply

You need to supply these tools and equipment:

•Ratcheting Phillips-head torque screwdriver

•Panduit crimping tool

•6-gauge copper ground wire

•Four leads of 18-gauge copper wire

•Wire stripping tool

Ground the Switch

Follow these steps:

Step 1 Remove the ground lug and the two number-10-32 screws from the rear panel of the switch.

Step 2 If your 6-gauge ground wire is insulated, strip it to 0.5 inch (12.7 mm).

0.5 inch (12.7 mm)

17