Cisco Systems WS-X6066-SLB-S-K9 manual System Requirements, Memory Requirements, Power Supply

Environmental and System Requirements

System Requirements

Before you install the CSM-S in the Catalyst 6500 series switch, make sure that the switch meets the hardware and software requirements listed in this section.

Caution You can use the Multilayer Switch Feature Card (MSFC2), which is internal to the Catalyst 6500 series

switch, to route traffic on either the client side or the server side of the CSM-S, but not both simultaneously (unless policy-based routing is used).

Memory Requirements

The CSM-S memory is not configurable.

Power Supply

You can place the CSM-S in any slot in the Catalyst 6500 series chassis except for the slots that are occupied by the supervisor engine and the standby supervisor engine. The CSM-S operates on power that is supplied by the chassis. Up to four CSM-S modules can be supported by each switch chassis.

Hardware Supported

Before you can use the Catalyst 6500 series CSM-S, you must have a Supervisor Engine 2 with an MSFC2 and any module that has ports to connect server and client networks.

Caution The WS-X6066-SLB-S-K9 CSM-S are not fabric enabled, but the module can operate in a fabric-enabled chassis like any other nonfabric module.

Table 3 lists the supported hardware and software for the CSM-S.

Table 3	Supported Hardware and Software
Product Number		Minimum Cisco	Recommended	Recommended
		IOS Release	Cisco IOS Release	Catalyst OS Releases
Content Switching Module
Supervisor Engine 2 with MSFC2		12.2(18)SXD	12.2(18)SXD	Not applicable
Console Cable
72-876-01			Not applicable
Accessory Kit
800-05097-01			Not applicable

Catalyst 6500 Series Switch Content Switching Module with SSL Installation Note

10 78-16856-01