Cisco Systems WS-X6066-SLB-S-K9 manual Installing the CSM-S, Software Requirements

Installing the CSM-S

Software Requirements

Caution The CSM-S release is not supported by the Catalyst operating system.

Table 4 lists the software versions for the CSM-S.

Table 4	CSM-S Software Requirements
CSM-S Software Release		Software Part Number	Hardware	Catalyst Operating System	Cisco IOS Release
2,1(1)		SC6K-1.1-CSM-S	WS-X6066-SLB-S-K9	Not Applicable	Cisco IOS software
					Release 12.2(18)SXD

Software Compatibility

The minimum software version that is listed is the minimum release that is required to support the

CSM-S hardware with a given supervisor engine to perform basic CSM-S configuration.

The recommended version is the base version to support the new commands for a given CSM release.

Table 5 and Table 6 list the CSM-S software release compatibility.

Table 5 Cisco IOS Software on the Supervisor Engine 2 and MSFC 2

CSM-S Software	Cisco IOS Software
2.1(1)	12.2(18)SXD or higher for the features new to CSM-S release 2.1(1).

Table 6 Catalyst Operating System on the Supervisor Engine and Cisco IOS Software on the MSFC

CSM-S Software	Catalyst Operating System Software
2.1(1)	The CSM-S is currently not supported by the Catalyst operating system.

Installing the CSM-S

These sections describe how to install the CSM-S:

•Preparing to Install the CSM-S, page 12

•Required Tools, page 12

•Installing and Removing the Module, page 12

Caution The WS-X6066-SLB-S-K9 Content Switching Module with SSL is not fabric enabled.

Catalyst 6500 Series Switch Content Switching Module with SSL Installation Note

78-16856-01 11