Catalyst
Step 3 Approximately 30 seconds after the switch powers on, it begins the
During POST, the SYSTEM LED blinks green, and the other LEDs turn green.
When POST is complete, the SYSTEM LED turns green, and the other LEDs turn off.
Troubleshooting:
If the SYSTEM LED blinks green, does not turn green, or turns amber, contact your Cisco representative or reseller. The switch failed the POST.
Step 4 Press and hold the Mode button until all of the LEDs next to the console port turn green. You might need to hold the button for 3 to 5 seconds.
|
|
|
| SYST | |
The switch is now in Express Setup mode. |
|
|
| STAT | |
|
|
| D | PLX | |
|
|
|
| SPD | |
| M O DE |
|
| ||
Before going to the next step, make sure that |
|
|
| PoE | |
|
| CO N | SO LE | PD | |
|
|
|
|
| |
all LEDs next to the console port are green. |
|
|
|
|
|
Troubleshooting: |
|
|
|
|
|
If the LEDs blink after you press the Mode |
|
|
|
| 208780 |
button, release it. Blinking LEDs mean that |
|
|
|
| |
the switch is already configured and cannot |
|
|
|
|
|
go into Express Setup mode. For more |
|
|
|
|
|
information, see the “Resetting the Switch” |
|
|
|
|
|
section on page 21. You can also use the CLI |
|
|
|
|
|
setup program described in the switch |
|
|
|
|
|
hardware guide. |
|
|
|
|
|
Catalyst
| 5 | |
|