Cisco Systems 6500 Do command, Command EXEC-level command to be executed, Configuration mode

Chapter 2 Commands for the Catalyst 6500 Series SSL Services Module

do

do

To execute EXEC-level commands from global configuration mode or other configuration modes or submodes, use the do command.

		do command
Syntax Description		command	EXEC-level command to be executed.
Defaults		This command has no default settings.
Command Modes		Global configuration or any other configuration mode or submode from which you are executing the
		EXEC-level command.
Command History		Release	Modification
		Cisco IOS Release	Support for this command was introduced on the Catalyst 6500 series
		12.1(13)E and	switches.
		SSL Services Module
		Release 1.1(1)
Usage Guidelines
	Caution	Do not enter the do command in EXEC mode. Interruption of service may occur.
		You cannot use the do command to execute the configure terminal command because entering the
		configure terminal command changes the mode to configuration mode.
		You cannot use the do command to execute the copy or write command in the global configuration or
		any other configuration mode or submode.
		This example shows how to execute the EXEC-level show interfaces command from within global
Examples
		configuration mode:
		ssl-proxy(config)#do show interfaces serial 3/0
		Serial3/0 is up, line protocol is up

Hardware is M8T-RS232

MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec, rely 255/255, load 1/255

Encapsulation HDLC, loopback not set, keepalive set (10 sec)

Last input never, output 1d17h, output hang never

Last clearing of "show interface" counters never

	.
	.
	.
		ssl-proxy(config)#
		Catalyst 6500 Series Switch SSL Services Module Command Reference
2-26		OL-9105-01