Cisco Systems 6500 Standby authentication, Standby delay minimum reload, Standby ip, Standby name

Chapter 2 Commands for the Catalyst 6500 Series SSL Services Module

interface ssl-proxy

Table 2-1 Subinterface Configuration Submode Command Descriptions (continued)

Syntax	Description
[no] shutdown	Shuts down the subinterface. Use the no form of this command to put the
	subinterface in service.
standby [group-number] {authentication	Configures redundancy on the subinterface. See the following commands for
text string} {delay minimum [min-delay]	valid values:
reload [reload-delay]} {ip [ip-address	•	standby authentication
[secondary]]} {mac-address mac-address}
	•	standby delay minimum reload
{mac-refresh seconds} {name
group-name} {preempt [delay{minimum	•	standby ip
delay reload delay sync delay}]}
	• standby mac-address
{priority priority} {redirects [enable
disable] [timers advertisement holddown]	•	standby mac-refresh
[unknown]} {timers [msec] hellotime	•	standby name
[msec] holdtime} {track object-number
		standby preempt
[decrement priority]} [version {1 2}]	•
	•	standby priority
	•	standby redirects
	•	standby timers
	•	standby track
	• standby use-bia
	•	standby version
timeout absolute minutes seconds	Sets the session timeout values for this interface. Valid values for minutes are
	from 0 to 71582787 minutes. Valid values for seconds are from 0 to 59
	seconds.

The valid values for configuring HSRP are as follows:

•group-number—(Optional) Group number on the interface for which HSRP is being activated; valid values are from 0 to 255 for HSRP version 1; valid values are from 0 to 4095 for HSRP version 2. See the “standby version” section on page 2-116for information about changing the HSRP version. If you do not specify a group-number, group 0 is used.

•ip ip-addr—Specifies the IP address of the HSRP interface.

•priority priority— Specifies the priority for the HSRP interface. Increase the priority of at least one interface in the HSRP group. The interface with the highest priority becomes active for that HSRP group.

•prempt —Enables preemption. When you enable preemption, if the local router has a hot standby priority that is higher than the current active router, the local router attempts to assume control as the active router. If you do not configure preemption, the local router assumes control as the active router only if it receives information indicating that no router is in the active state (acting as the designated router).

•delay—(Optional) Specifies the preemption delay. When a router first comes up, it does not have a complete routing table. If it is configured to preempt, it becomes the active router but cannot provide adequate routing services. You can configure a delay before the preempting router actually preempts the currently active router.

Catalyst 6500 Series Switch SSL Services Module Command Reference

2-28 OL-9105-01