Cisco Systems 520 manual Install the Switch On a Desk or Shelf, Troubleshooting

Chapter 3 Installing the Switch

Install the Switch On a Desk or Shelf

Install the Switch On a Desk or Shelf

Follow these steps:

Step 1	Locate the adhesive strip with the rubber feet in the accessory kit.
Step 2	Remove the four rubber feet from
	the adhesive strip, and attach them
	to the recessed areas on the bottom
	of the unit. This prevents the switch
	from sliding on the desk or shelf.
	We strongly recommend that you	1
		ies erS 520 ss	Exprest		ETN R HE T E R EPOW
	attach the rubber feet. Doing so
			lyaatC	3	2
			4
			8
			7
			6
			5
	helps prevent airflow restriction				1
	and overheating.

NI MD A
EPo
	RTL A
T	YS S

201617

Step 3	Place the switch on the desk or shelf near an AC power source.
Step 4	Use the supplied switch power cable to connect the switch to an AC power source.
Step 5	Wait until the System LED blinks green and then turns solid green. A solid green SYSTEM
	LED means that the switch is operating properly.
	Troubleshooting:
	If the SYSTEM LED does not blink green, does not turn solid green, or turns amber, contact
	your Cisco representative or reseller. The switch failed the power-on self-test (POST).

	User Guide for the Catalyst Express 520 Switches
OL-12761-02		3-7