Cisco Systems 520 manual Remove an SFP Module from an SFP Module Slot

Chapter 4 Connecting to the Switch

Remove an SFP Module from an SFP Module Slot

Step 4

Insert the SFP module into the slot until you feel the connector on the module snap into place in the rear of the slot.

	Catalyst
	Express
	520	Series
	1		201621
Step 5	On fiber-optic SFP modules, remove the dust plugs from the optical ports, and store them for
	later use.
Step 6	Disconnect the cable from the SFP module, and insert a dust plug into the cable end.

Remove an SFP Module from an SFP Module Slot

	Tip	For reattachment, note which cable connector plug is send (TX) and which is
		receive (RX).
		Follow these steps:
Step 1	Attach an ESD-preventive wrist strap to your wrist and to a bare metal surface on the chassis.
Step 2	Disconnect the cable from the SFP module, and insert a dust plug into the cable end.
Step 3	Unlock and remove the SFP module.

If the module has a bale-clasp latch, pull the bale out and down to eject the module. If the bale-clasp latch is obstructed and you cannot use your finger to open it, use a small, flat-blade screwdriver or other long, narrow instrument to open the bale-clasp latch.

Catalyst Express

520

Series

201622

Step 4

Grasp the SFP module between your thumb and index finger, and carefully remove it from the module slot.

	User Guide for the Catalyst Express 520 Switches
OL-12761-02		4-5