Teac SZ-1 owner manual Output Settings, Link, DF Digital Filter, Normal display

Page 15

Output Settings

PLAY AREA .//

1In the stop mode, press and hold the PLAY AREA button for more than 2 seconds.

The unit enters setup mode, and “ >***” appears on the display. (*** changes depending on your setting.)

In the following cases, the setup mode will be cancelled:

Leave the unit idle for 10 seconds.

Press and hold the PLAY AREA button for more than 2 seconds once again.

2Repeatedly press the PLAY AREA button to select the menu item to be changed.

i.LINK DF DSD

(normal display)

3Use the SKIP buttons (.//) to select the options within the menu item.

4Press and hold the PLAY AREA button for more than 2 seconds (or leave the unit idle for 10 seconds) to exit the setup mode.

<Switching off the power without exiting the setup mode may cause problems. Do not turn the unit off.

<Settings are stored even when power is turned off and the unit is unplugged. If left unplugged for an extended period, the settings may be lost.

Available menu item and options

i.LINK

Used to select an i.LINK output setting. “60958”, “PCM” or “OFF” are available.

You can also use the i.LINK button of the remote control unit. See page 14 for details.

DF (Digital Filter)

Used to select a digital filter. “Wide” or “Narrow” are available.

DSD

Select “Normal” to output DSD after processing and “Direct” to output the audio signal without running it through the processor.

The analog level in the Direct mode is 3 dB lower than in the Normal mode.

(Normal display)

Select this to exit the setting mode.

15

Image 15
Contents Super Audio CD Player For U.S.A Important Safety InstructionsContents Read this before operation Before UseWhat’s in the box Conventions about this manualDiscs Type of discs that can be played on this systemFollowing discs cannot be played with this unit Connections Analog audio output terminals Word sync connectorSignal GND connection Power cord receptacleFront panel features Front PanelDisplay Understanding the remote control unit Battery Replacement Remote Control UnitRestoring factory settings How to insert the batteriesOpening and closing the tray Pausing playbackPlayback Stopping playbackSelecting the playback area Skipping playbackSelecting a track Fast scanningTrack repeat Repeat modeChanging the display mode Display dimming60958 Link Audio Output SettingUse the Word button to switch between Word on and Word OFF Word syncNormal display Output SettingsLink DF Digital FilterData transfer rate How to connect multiple i.LINK-capable devicesLink Ieee Copyright protection system DtcpSettings introduction Exit the setup menu by pressing Setup once moreUse the cursor buttons to navigate the menus Settings Setup Menu Chart Settings Speaker Setup Settings Audio SetupSelect Test Start and press the Enter button Speaker distanceSpeaker levels SP Level Test tone length Test toneTroubleshooting MaintenanceBeware of condensation Specifications Page Teac Esoteric Company