Cisco Systems 4840G Verify that you are in the right directory, SLB-Switch#copy tftp flash

Chapter 3 Configuring the Catalyst 4840G Processor

Using Flash PC Cards

Copying a System Image from a TFTP Server to a Flash PC Card

You should have a copy of the current system image on a Flash PC card in case the file in Flash memory becomes corrupted. You can replace the system software by copying the backup image from the Flash PC card to the onboard Flash memory.

Note Be sure that you have a properly formatted Flash PC card in the appropriate slot before beginning this procedure.

To copy the system image from the TFTP server to a Flash PC card, perform this task:

Step 1

Step 2 Step 3

Command	Purpose
SLB-Switch# cd filesystem:	Change the Flash device to the slot that holds the Flash PC
	card.
SLB-Switch# pwd	Verify that you are in the right directory.
SLB-Switch#copy tftp flash:	Copy a file from a TFTP server to Flash memory.

This example shows how to copy a system image file from the default TFTP server to the current Flash PC card:

SLB-Switch#copy tftp flash:

Source filename []? cat4840G-in-mz.X.binAddress or name of remote host [172.8.1.129]? y Destination filename [cat4840g-in-mz.X.bin]? y

5746016 bytes available on device slot0, proceed? [confirm] y

Now that you have configured the processor, see Chapter 4, “Configuring Interfaces,” for instructions on interface configurations for your SLB switch.

Catalyst 4840G Software Feature and Configuration Guide

3-10 78-10416-02