Rear Panel Description
Mode Button
To change the mode being displayed by a port LED, press the Mode button to highlight in sequence each of the modes: STAT, UTL, and ID. The Mode button is independent of the Collision LED. When the desired mode is selected, release the button to make the change. As long as you hold the Mode button down, the mode does not change. The selected mode remains on for 30 seconds before returning to the default mode of STAT (port status).
Rear Panel Description
The rear panel of the FastHub provides an AC power receptacle and a redundant DC power system (RPS) receptacle (see Figure
If you want to use the internal power supply, which is an autoranging unit supporting input voltages of 90 to 127/200 to 250 VAC, use the supplied AC power cord to connect the AC power receptacle to an AC power outlet.
If you are using the RPS, the supplied AC power cord must not be plugged in. See the Cisco RPS documentation for detailed information on connecting to the RPS.
Warning Use the Cisco RPS (model
Figure 1-4 Rear Panel Connector
H10261
|
| CONSOLE PORT | DC INPUTS FOR REMOTE |
| ||
| RATING | POWER SUPPLY | SPECIFIED |
| ||
| For FastHub 200 |
|
|
| ||
IN MANUAL. |
| |||||
and Catalyst only | +5V 6A | +12V 1A | AUI | |||
0.5A/0.3A |
|
|
|
| For Catalyst only | |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Fan | Redundant | ||
AC power | power system | |||
receptacle | receptacle | |||