Chapter 4 Installing Hardware Options
Working with Hard Disk Drives
Installing an SAS Hard Disk Drive
Note The
To install an SAS hard disk drive in the
Step 1 Inspect the new drive for any signs of damage.
Step 2 Review the information in the “Safety Warnings” section on page
Step 3 Make sure that the chassis cover is in place and fully closed.
Step 4 Open the drive tray handle.
Step 5 Gently push the drive assembly into the bay until the drive stops. (See Figure
Note If you are replacing disk00 in a
| Cisco Wide Area Application Engine 512 and 612 Hardware Installation Guide |
|