Serial Cable CAB−232FC
This section presents the cable assembly and pinouts for the CAB−232FC serial cable.
The cable gender for this product (part number 72−0794−01) is Male DB−60 to Female DB−25, mode − DCE.
This cable is used in the following systems: the Cisco 7000 family, Cisco 4000 series, Cisco 3600 series, Cisco 2500 series, Cisco 1600 series, Cisco access servers, and AccessPro PC cards. This cable has a male DB−60 connector on the Cisco end and a female DB−25 connector on the network end.
EIA/TIA−232 DCE Cable Pinouts (DB−60 to DB−25)
The table below shows the EIA/TIA−232 DCE cable pinouts (DB−60 to DB−25).
Note: The arrows indicate signal direction:
∙−−−> indicates DTE to DCE
∙<−−− indicates DCE to DTE
60 Pin | Signal | Description | Direction | 25 Pin | Signal | |
| ||||||
J1−50 |
|
|
|
|
| |
J1−51 | MODE_0 | Shorting |
|
|
| |
| − | − | − | |||
|
|
| ||||
J1−46 | GNDShield | group |
|
| Shield | |
Single | − | J2−1 | ||||
| GND | GND | ||||
|
|
|
| |||
|
|
|
|
|
| |
J1−36 |
|
|
|
|
| |
Shield | RxD/TxD | Twisted pair | <−−− | J2−2 | TxD | |
|
|
|
|
|
| |
J1−41 | − | no. 9 | − | Shield | − | |
| ||||||
Shield | TxD/RxD | Twisted pair | −−−> | J2−3 | RxD | |
|
|
|
|
|
| |
J1−35 | − | no. 5 | − | Shield | − | |
| ||||||
Shield | CTS/RTS | Twisted pair | <−−− | J2−4 | RTS | |
|
|
|
|
|
| |
J1−42 | − | no. 10 | − | Shield | − | |
| ||||||
Shield | RTS/CTS | Twisted pair | −−−> | J2−5 | CTS | |
|
|
|
|
|
| |
J1−43 | − | no. 4 | − | Shield | − | |
| ||||||
Shield | DTR/DSR | Twisted pair | −−−> | J2−6 | DSR | |
|
|
|
|
|
| |
J1−45 | − | no. 3 | − | Shield | − | |
| ||||||
| Circuit |
| − | J2−7 |
| |
Shield | GND | Twisted pair | Circuit | |||
|
| |||||
|
| no. 1 | − | Shield | GND | |
J1−44 | − |
| −−−> | J2−8 | DCD | |
LL/DCD |
| |||||
|
|
|
|
|
|