Cisco Systems 10000 Series specifications LEDs, LED Label Color State Meaning, 10-4

Chapter 10 1-Port Gigabit Ethernet Half-Height Line Card Overview

LEDs

LEDs

The 1-port Gigabit Ethernet half-height line card LEDs are listed in Figure 10-1.

Figure 10-1 1-Port Gigabit Ethernet Half-Height Line Card Faceplate Description

		2	3
CISCO 10000			RX
	FAIL	LINK	TX
			0

6 7

1

4

TX RX

GIGABIT ETHERNET

76294

1

1

2

3

Ejector levers

FAIL LED

RX (receive) LED

4

6

7

SFP module port (TX/RX)

LINK LED

TX (transmit) LED

Table 10-3provides a description of the 1-port Gigabit Ethernet half-height line card LEDs.

Table 10-3	LED Description
LED Label		Color	State	Meaning
FAIL		Yellow	Off	Off when line card is working properly. Turns on for
				a few seconds during line card power-on self test
				(POST), then turns off.
			Blinking	The FAIL LED blinks during the following SFP
				module faults:
				• An SFP module other than a Cisco brand is
				inserted.
				• A non-Gigabit Ethernet SFP module is inserted.
				• A hardware problem occurs in a valid SFP
				module.
			On	The FAIL LED may blink in different patterns for certain
				POST failures (slot ID parity error and BPE loopback
				test failure).
				If the line card POST fails.
				If any failure occurs.
RX (receive)		Green	On	The port is receiving traffic.
			Off	The port is not receiving traffic.
TX (transmit)		Green	On	The port is transmitting traffic.
			Off	The port is not transmitting traffic.

Cisco 10000 Series Routers Line Card Hardware Installation Guide

10-4 OL-6773-04