Cisco Systems HC-477 manual HC-479

Index

setting the frame type 422

using the clock source command 422 using the controller e1 command 445 using the framing command 422, 440 using the national bits command 422, 440

E3 controller

configuration prerequisites 420 configuring 424

configuring clear channel serial 425 configuring clocking 421 configuring the frame type 421 configuring the national reserved bits 421 E3 configuration mode 425

setting the cable length 421 setting the card type 423

using the cablelength command 421 using the clock source command 421 using the framing command 421

using the hw-module subslot cardtype com- mand 423, 424

using the mode command 425

using the national bits command 421, 427 using the show controllers command 426, 428

E3 mode

changing to T3 mode 423 echo disable command 64, 66

encap command (Frame Relay) 164, 165, 172 encapsulation command

on ATM vc-classes 35

on POS interfaces 86, 272, 280, 325 on serial interfaces 351, 356

encapsulation frame relay command 164 end command 399

Ethernet interface

configuring an attachment circuit 142 configuring flow control 128 configuring MAC accounting 128, 141 configuring the IP address and subnet mask 135 configuring the MAC address 128, 136 configuring the MTU 128, 136

default settings flow control 128 MAC accounting 128 MAC address 128 mtu 128

displaying Ethernet interfaces 137 displaying MAC accounting statistics 142 enabling flow-control 136

enabling Layer 2 transport mode 143 Gigabit Ethernet standards 130

IEEE 802.3 Physical Ethernet Infrastructure 130

IEEE 802.3ab 1000BASE-T Gigabit Ether- net 130

IEEE 802.3ae 10 Gbps Ethernet 130

IEEE 802.3z 1000 Mbps Gigabit Ethernet 130

Layer 2 VPN

configuring Layer 2 protocol tunneling and data units 143

overview 129

preparing a port for Layer 2 VPN 142 VLAN support 464

using the flow-control command 128, 136 using the interface command 135

using the ipv4 address command 135 using the l2protocol command 143 using the l2transport command 143 using the mac address command 128, 136 using the mac-accounting command 128 using the mtu command 128, 136 using the negotiation auto command 136 using the no shutdown command 136 VLANs

802.1Q frames tagging 463 assigning a VLAN AC 466

configuring a Layer 2 VPN attachment cir- cuit 469

configuring an attachment circuit 470 configuring Layer 2 VPN 471 configuring native VLAN 467 configuring subinterfaces 465 configuring the native VLAN 468 displaying VLAN interfaces 467 displaying VLAN trunks 467 MTU inheritance 463

native VLAN description 463 overview 462

removing a subinterface 472 subinterface overview 463

	Cisco IOS XR Interface and Hardware Component Configuration Guide
OL-14352-01		HC-479