3 Get started
Charge the headset
Warning
•• Before you use your headset for the first time, charge the battery for four hours for optimum battery capacity and lifetime.
•• Use only the original USB charging cable to avoid any damage.
•• End a call before charging the headset, as connecting the headset for charging will power off the unit.
Plug the headset into a powered USB port with an USB charging cable.
»»LED turns white during charging and turns off when the headset is fully charged.
Tip
•• Normally, a full charge takes three hours.
Pair the headset with your mobile phone
Before you use the headset with your mobile phone for the first time, pair it with the mobile phone. A successful pairing establishes a unique encrypted link between the headset and the mobile phone.The headset stores the last eight links in the memory. If you try to pair more than eight devices, the link for the earliest paired devices is replaced by the new link.
1Make sure that the mobile phone is turned on and its Bluetooth feature is activated.
2Make sure that the headset is charged and turned off.
3 Press and hold 
until the LED starts
flashing white and blue alternately.
»»The headset is in pairing mode, which lasts five minutes.
4Pair the headset with the mobile phone. For details, refer to the user manual of your mobile phone.
A sample pairing is shown below.
1Activate the Bluetooth feature of your mobile phone, search for the model number of the headset.
2On mobile phones featuring Bluetooth 2.1+EDR or higher, you do not need to enter a pass code.
3From the found devices, select Philips SHB7000.
•Enter "0000" (4 zeros) if prompted to enter the pin code of the headset.
10:35 | 10:36 | 10:37 |
Settings | Connectivity | Settings |
| Settings | Connectivity | ||
Bluetooth |
| Devices Found |
|
|
|
|
|
Add |
| Philips SHB70006 | Enter Password | ||||
Bluetooth |
|
|
|
| **** |
| |
device |
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
| 0000 |
|
|
| Select |
|
|
|
|
|
Select | Back | Back | Select | Back | |||
6EN