Cisco Systems CISCO1751 Checking FXS VIC Installation, Port ISDN BRI Card, Description, Signal

Installing WAN and Voice Interface Cards

Figure 5 shows the wiring pattern for an E&M connector, and Table 2 lists the E&M pinouts.

Note The E&M VIC pinout depends on the PBX type and connection. Pins that are not used should not be connected.

Figure 5

1

RJ-48S Wiring for E&M Connectors

8

H11421

Table 2		E&M Pinouts
Pin	Signal		Description
1	SB		–48V signaling battery
2	M-lead		Signaling input
3	R		Ring, audio input
4	R or R1		Ring, audio input/output, or
			output
5	T or T1		Tip, audio input/output, or
			output
6	T		Tip, audio input
7	E-lead		Signaling output
8	SG		Signaling ground return

Checking FXS VIC Installation

If you installed an FXS VIC, connect a handset to the VIC port. When router power is on, you should be able to hear the dial tone when you lift the handset. The dial tone should stop after you dial a digit. If you have trouble, use the show voice port command to make sure that the VIC is installed correctly, or try connecting a different handset to the VIC.

2-Port ISDN BRI Card

The ISDN BRI NT/TE voice interface card provides a client-side (TE) ISDN S/T physical interface for connection to an NT1 terminating an ISDN telephone network. It can also be configured to provide a network termination (NT) interface with phantom power. Each of its two ports can carry two voice calls (one over each ISDN B channel), for a total of four calls per ISDN BRI card.

Cisco 1751 Voice-over-IP Quick Start Guide

6 78-11259-05