Cisco Systems OC-12/STM-14 manual Contents

Page 1

Cisco IOS Software Configuration for the 1-Port Channelized OC-12/STM-4 (DS3) Line Card

This document describes the software configuration procedure for the 1-port channelized OC-12/STM-4 (DS3) line card on the Cisco 12000 Series Router. This line card is sometimes referred to as the Channelized OC-12 to DS3 line card or the OC12-DS3 line card.

Feature History for the 1-Port Channelized OC-12/STM-4 (DS3)

Release

Modification

11.2(19)GS4

This feature was introduced.

 

 

12.0(8)S

This feature was introduced on the 12.0 S train.

 

 

Finding Support Information for Platforms and Cisco IOS Software Images

Use Cisco Feature Navigator to find information about platform support and Cisco IOS software image support. Access Cisco Feature Navigator at http://www.cisco.com/go/fn. You must have an account on Cisco.com. If you do not have an account or have forgotten your username or password, click Cancel at the login dialog box and follow the instructions that appear.

Contents

•Prerequisites for the 1-Port Channelized OC-12/STM-4 (DS3) Line Card, page 2

•Information About the 1-Port Channelized OC-12/STM-4 (DS3) Line Card, page 2

•How to Configure the 1-Port Channelized OC-12/STM-4 (DS3) Line Card, page 2

•Configuration Examples for the 1-Port Channelized OC-12/STM-4 (DS3) Line Card, page 17

•Additional References, page 19

Corporate Headquarters:

Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA

Copyright © 2004 Cisco Systems, Inc. All rights reserved.

Page 1 Page 2
Image 1
Page 1 Page 2
Contents
Contents Router# show controller oc12 1/0 Configuring the OC-12 ControllerRouterconfig# controller OC12 1/0 Router# configure terminalConfiguration Command Default Value Configuring the DS3 Serial InterfaceRouterconfig-if#ip address 10.1.2.3 Routerconfig# interface serial 1/01Router# copy running-config startup-config Cisco Remote Connection ManagementNo framing c-bit m13 No dsu modeCisco digital-link kentrox larscom No dsu bandwidth Kilobits/secSelecting a DSU Mode Verifying Local and Remote DS3 Port SettingsSetting the Sending and Receiving Rate Configuring the DSU Bandwidth RangeConfiguring Cyclic Redundancy Checks Using show Commands to Check System StatusConfiguring the Clock Source Enabling Payload ScramblingRouter# show controllers oc12 1/0 Show controllers oc12 slot/portShow controllers oc12 detail Show controllers oc12 slot/portchannel#Router# show controllers oc12 1/01 Ip subnet-zero Router# show running-configOC-12 Controller Loopback Mode Using Loopback CommandsLoopback modes Configuration Mode Command DS3 Channel Loopback Mode Configuring DS3 Port BER TestingNo loopback local network remote configuration command Bert Pattern To Invoke Command Checking Bit Errors Using a BertUsing show Commands to Verify Bert Configuration Entering Errors in BER TestsRouter# show controller oc12 1/01 bert Bert Bert Information ExplanationBert Information Explanation Routerconfig-if#ip address 1.1.5.1 Technical Assistance Related DocumentsRelated Topic Document Title Description Link