Cisco IOS Software Configuration for the
How to Configure the
Last clearing of "show interface" counters 1d16h Queueing strategy: fifo
Output queue 0/40, 0 drops; input queue 0/75, 0 drops 5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
18617 packets input, 1537679 bytes, 0 no buffer Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 parity
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort 16834 packets output, 2198122 bytes, 0 underruns
0 output errors, 0 applique, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions Router#
•The following commands are line card specific and are executed from the line card only. To log on to the line card and execute the following commands, use the attach [slot number] EXEC command, as shown in the following example:
Router# attach 1 slot1# enable slot1#
•To display controller information about an instance of an
–show controllers oc12 slot/port
Display information about an
Router# show controllers oc12 1/0
OC12_CH_DS31/0 |
|
|
|
| |
The current state of the controller is up |
| ||||
Current configurable parameter settings: |
| ||||
Clock | source is INTERNAL, Loopback is NONE |
| |||
SECTION |
|
|
|
|
|
LOF = | 0 | LOS = 0 |
| RDOOL = 0 | BIP(B1) = 0 |
Active Alarms: None |
|
|
| ||
LINE |
|
|
|
|
|
AIS = | 0 | RDI | = 0 | FEBE = 0 | BIP(B2) = 0 |
Active Alarms: None |
|
|
| ||
PATH 1 |
|
|
|
|
|
AIS = | 0 | RDI = 0 |
| FEBE = 0 | BIP(B3) = 0 |
LOP = | 0 | NEWPTR = 0 | PSE = 0 | NSE = 0 | |
Active Alarms: None |
|
|
| ||
S1S0 = 02, C2 = 04 |
|
|
| ||
PATH TRACE BUFFER : STABLE |
|
| |||
PATH 2 |
|
|
|
|
|
AIS = | 0 | RDI = 0 |
| FEBE = 0 | BIP(B3) = 0 |
LOP = | 0 | NEWPTR = 0 | PSE = 0 | NSE = 0 |
Active Alarms: None
S1S0 = 03, C2 = FF
PATH TRACE BUFFER : STABLE
(Remainder of displayed text omitted from example.)
Cisco IOS Release 12.0(8)S
9