BC/BL/BLR2604 Programming Guide
2604 Programming guide
This document is to be used with Baracoda Barcode Scanners :
BC2604
BL2604
BLR 2604
Important notice:
Every effort is made to ensure the accuracy of our product information; however, we accept no responsibility for errors or omissions including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose. We shall not be liable for errors contained herein or for incidental consequential damages in connection with the furnishing, performance, or use of this material.
Specifications or version may be subject to change without notice. The actual specification and version are based on the product delivered.
INTRODUCTION
Scanning a series of programming bar code labels can configure the scanner. The scanner must be properly powered before programming.
During the programming mode, the scanner will acknowledge a good and valid reading with a short beep. It will give long beeps for either an invalid or bad reading.
PROGRAMMING OPTIONS
Programmable options are divided into 2 groups. The first group includes the options that show the general behaviour of the scanner. The second group sets the decoding parameters for each barcode symbology.
SCANNING INSTRUCTIONS
The Programming Guide barcodes should be scanned with a full charged set of batteries.
The BLR2604 scanning distance is 60 cm.
© Baracoda 2004 | Page 1/22 |