BC/BL/BLR2604 Programming Guide
4General configuration
Start of Configuration
4.1Scanning mode selection
The scanner becomes inactive as soon as the data is transmitted. It must be triggered to become active again.
In auto scan mode, the scanner is still active after the data is transmitted, but the successive transmission of the same bar code is not allowed when the trigger switch is pressed again.
Trigger mode
Auto scan mode
4.2Good read beeper tone selection
You can use this option to set frequency and / or duration of the buzzer after successful reading.
Low
High
Medium
Disable
4.3Sound duration
Medium(50 ms)
long(120 ms)
Very short(5 ms)
Short(20 ms)
End of Configuration
© Baracoda 2004 | Page 6/22 |