Baracoda Computer Accessories manual Reset all parameters, Erase all barcodes in memory

Data Capture

for Workforce

in Motion

1/ General Configuration

1.1/ Reset all parameters:

The reading of the "Default settings” label turns all the parameters of the BaracodaPencil2 back to default settings and switches it off.

Reset to factory defaults

1.2/ Erase all barcodes in memory

The BaracodaPencil2 has the ability to store barcodes in its internal memory (both in batch mode and in Real Time with “No Data Loss Mode” ON). By reading the following barcode you will empty the internal memory of the scanner.

Empty memory

1.3/ Baracoda advanced features

1.3.1/ Switch on delay

In order to switch on the BaracodaPencil2 in its standard mode, you should just press the trigger. You can set up the scanner to be switched on only after keeping the trigger pressed for two seconds by reading the appropriate barcode.

Switch on delay : 2 seconds Switch on delay : 0 second (*)

1.3.2/ Shutdown timers

There are two differents “shutdown timers”:

-when connected timer : delay between the last scanned barcode and the switch off when the scanner is connected to a host

-Not connected timer : delay between the last scanned barcode and the switch off when the scanner is not connected to any host

It is possible to set those timers to ‘infinite’. In that case, the scanner will stay all the time ON.

Set shutdown timers to infinity

BaracodaPencil2 – Programming Guide v1.7 - 5 -