Baracoda All in One Printer manual Default 0xf0, 0x50, 0x08

						Data Capture
						for Workforce
						in Motion
Command	Header	Length		Payload		Answer
Set sniff	0x09	00 04		[MSB of MinSniff interval, LSB of MinSniff		0x09 00 01 01 if done
				interval, MSB of MaxSniff interval, LSB of
				MaxSnif interval]		0x09 00 01 00 if not
Command	Header	Length	Payload			Answer
Set sniff	0x09	00 08	[MSB of MinSniff interval, LSB of MinSniff			0x09 00 01 01 if done
(advanced)			interval, MSB of MaxSniff interval, LSB of
			MaxSnif interval,			0x09 00 01 00 if not
			Sniff Attempts MSB, Sniff attempts LSB,
			Sniff timeout MSB, Sniff timeout LSB]
(default 0xf0, 0x50, 0x08, 0x08)
Command	Header	Length		Payload	Answer
Get sniff	0x10	00 00			0x10 00 08 [MSB of MinSniff interval, LSB of MinSniff interval,
					MSB of MaxSniff interval, LSB of MaxSnif interval, Sniff
					Attempts MSB, Sniff attempts LSB, Sniff timeout MSB, Sniff
					timeout LSB]

When setting only MinSniff and MaxSniff values, the default value 0x08 will be used for Sniff attempts and Sniff timeout.

Typical values are:

Full speed (full power)

MinSniff = 0

MaxSniff = 0

Very Low Power (low speed): (sniff of 500ms Only are accepted. If the remote device does not support sniffs of 500ms, no sniff will be used)

MinSniff = 0x0320

MaxSniff = 0x0320

Very Low Power (low speed): (sniff between 250ms to 500ms are accepted. No sniff will be used if the remote device does not support any sniff values in this specified range)

MinSniff = 0x0160

MaxSniff = 0x0320

Low Power (medium speed):

ToughRunners / ScanWear – Communication Protocol v1.2 - 33 -