Cisco Systems RE1000 How to change the power plug configuration, To attach the AC power plug

Page 5

RE1000 Range Extender

7.Move the extender to its primary location, then click Next. Your router tests the wireless connection to your relocated extender and prompts you if it needs further adjustment.

TIP

You can also connect the range extender by using Wi-Fi Protected Setup. For more information, see “Using Wi-Fi Protected Setup” on page 7.

Getting Started

How to change the power plug configuration

You can connect the extender’s built-in power plug directly to a wall power outlet. For a desktop or table-top setup, you can also remove the built-in plug and use an AC cable instead.

To attach the AC power plug:

1.Press the plug release latch, then slide the AC plug off the extender.

2.Slide the clip cover into the slot that held the AC plug, then connect the AC cable to the power connector.

Power connector

(European version of extender shown)

Image 5

Contents Getting Started Overview Introduction ContentsBottom How to install the range extenderTop TIP To attach the AC power plug How to change the power plug configurationIf the extender has not been set up yet How to open the browser-based utilityIf the extender has already been set up Using a wired computerHow to use the browser-based utility Using Wi-Fi Protected SetupConnecting the extender to an existing access point Wi-Fi Protected Setup light activityConnecting with the range extender’s PIN Connecting devices to your network through the extenderConnecting with the Wi-Fi Protected Setup Button Connecting with the extender’s PIN Connecting with the client device’s PINTo open the Site Survey How to use Site SurveyYou cannot access your range extender TroubleshootingTo fix the problem on Windows computers You cannot get your extender connectedTo fix the problem on Mac computers You have intermittent connection problems Environmental Specifications3425-01532