Remove the Cable
To replace the fan assembly cable, perform the following steps:
Step 1 Remove the front cover.
Step 2 Remove the fan assembly. See the “Remove the Fan Assembly Module” section on page 10.
Step 3 See Figure 4. Note that the cable has two “U” shaped bends that allow the cable to curve back into the brackets and fit snugly on the bottom of the fan module enclosure.
Figure 4 Location of Fan Cable Inside the Chassis
CISCO |
|
10000 | CISCO |
| 10000 |
AUX |
|
| AUX |
ACTIVITY |
|
ETHERNETLINK | ACTIVITY |
| ETHER |
| LINKNET |
62337
Step 4 Reach into the chassis and disconnect the cable from the rear bracket. Push the tabs on the bracket open. Step 5 Disconnect the cable from the front connector and remove the cable from the chassis.
Replace the Fan Assembly Cable
Note The cable has different connectors on each end.
Figure 5 | Fan Cable |
62338 |
|
|
| Male connector | Female connector | |
|
|
| Cisco uBR10012 Universal Broadband Router Fan Assembly Module |
|
|
|
|
|
|
| |
|
|
|
|
|
|
| 12 |
|
|
| |
|
|
|
| ||