Related Documentation, Cisco.com | Cisco Systems UBR10-FAN-ASSY=

•The following messages, if displayed, indicate that the system has detected a critical overtemperature condition or out-of-tolerance power inside the chassis:

Queued messages:

00:01:19:%ENVM-4-ENVWARN:+2.5 V measured at +2.59 00:01:19:%ENVM-4-ENVWARN:+5.15 V measured at +5.31

00:00:19:%ENVM-2-ENVCRIT:chassis core measured at 31C/87F 00:00:19:%ENVM-2-ENVCRIT:chassis inlet measured at 27C/80F 00:00:19:%ENVM-2-ENVCRIT:chassis outlet 1 measured at 30C/86F 00:00:19:%ENVM-2-ENVCRIT:chassis outlet 2 measured at 30C/86F

Although an overtemperature condition is unlikely at initial startup, ensure that heated exhaust air from other equipment is not entering the router’s inlet vent and that there is sufficient clearance around the sides of the chassis to allow cooling air to flow.

Note The above message could also indicate a faulty component or temperature sensor. Use the show environment or show environment table command to display the internal chassis environment.

If you experience trouble with the startup that is not resolved with these procedures, manually power off the router and contact a service representative for assistance and further instructions.

Perform the following if the FAN FAILURE LED is on:

•Reseat the fan assembly module.

•Remove the rear safety cover and be sure that the fan assembly module cable is connected securely.

Obtaining Documentation

Cisco provides several ways to obtain documentation, technical assistance, and other technical resources. These sections explain how to obtain technical information from Cisco Systems.

Cisco.com

You can access the most current Cisco documentation on the World Wide Web at this URL:

http://www.cisco.com/univercd/home/home.htm

Cisco uBR10012 Universal Broadband Router Fan Assembly Module

14	OL-5093-01