Chapter 1 Cisco 836 Router and SOHO 96 Router Cabling and Setup Quick Start Guide
Configure the Router
Configure the Router
Your router was shipped with a
SDM Configuration Instructions
If the Cisco Router and Security Device Manager (SDM) Quick Start Guide was included in your accessory kit, Cisco Router and Security Device Manager (SDM) is loaded on your router. Refer to that document to configure your Cisco 836 router.
The following link contains more information about SDM, including release notes and other SDM documentation.
www.cisco.com/go/sdm
Note SDM is not shipped with SOHO 96 routers.
CRWS Configuration Instructions
If you did not receive the Cisco Router and Security Device Manager (SDM) Quick Start Guide, Cisco Router Web Setup (CRWS) is loaded on your router. These instructions show you how to configure your router using CRWS. The CRWS software runs on Netscape versions 3.0 through 4.7, and on Internet Explorer version 4.0 or later.
Follow these steps to start the CRWS software and configure the router:
Step 1 Start, or restart, a PC connected to one of the router Ethernet ports (1, 2, 3, or 4). The PC need not be directly connected to the router. It can be connected through a switch or a hub.
Step 2 Open a web browser. Make sure that the browser is set to work in online mode.
•In Internet Explorer, click the File menu, and verify that the “work offline” option is unchecked.
•In Netscape, the default selection in the File menu is set to work online.
Step 3 Type in the universal resource locator (URL) shown in Figure
Figure 1-4 Type in the URL http://10.10.10.1
The CRWS dashboard (Figure 1-5) should appear after one or two minutes.
Cisco 836 Router and Cisco SOHO 96 Router Cabling and Setup Quick Start Guide
|
| ||
|
|