Cisco Systems 2940 appendix Cable Guard, LEDs, Stat LED, Dplx LED Syst LED SPD LED

Chapter 1 Overview

Front-Panel Description

The Cisco CWDM SFPs operate on single-mode fiber. The SFPs support both Gigabit Ethernet as well as fiber channel (1 Gigabit and 2 Gigabit) links. For more information about Cisco CWDM SFPs, see the Cisco CWDM SFP Transceiver Compatibility Matrix at this URL:

http://www.cisco.com/en/US/products/hw/modules/ps4999/products_device_support_table09186a00803bf095.html

Also see your SFP module documentation and the Cisco Small Form-Factor Pluggable Modules Installation Notes (not orderable but is available on Cisco.com).

For the latest information about SFP modules supported by the switch, see the release notes.

Cable Guard

You can order an optional cable guard to secure cables to the front of the switch and prevent them from being accidentally removed. To order a cable guard, contact your Cisco representative.

LEDs

There are four LEDs on the left panel of the switch, and there are port status LEDs above all the switch ports, as shown in Figure 1-3.

Figure 1-3 LEDs on Catalyst 2940 Switches

1

	3	SYST
4		STAT		1x	2x
	5	DPLX				3x
							4x
								5x
6		SPD
		MODE
		2
1	Port status LED		4		STAT LED
2	Mode button		5		DPLX LED
3	SYST LED		6		SPD LED

You can use these LEDs to monitor switch activity and performance:

89453

•The system (SYST) continually displays the system status. The SYST LED color shows the switch status.

•The status (STAT), duplex (DPLX), and speed (SPD) LEDs show the information that is being displayed by the port status LEDs. Pressing the Mode button cycles the LEDs through the STAT, DPLX, and SPD displays.

Catalyst 2940 Switch Hardware Installation Guide

1-6 OL-6157-01