Cabletron Systems 1800 manual Configuring Subscriber Addresses, Typical SVC Subscriber Screen

Configuring Subscriber Addresses

This operation configures the called and calling addresses that will be used for con- necting to an LLC2 host, or in X.25 call setup if SNA is being transported over a logical X.25 port. To complete the connection, the software must recognize where the call is coming from (calling address) and where it is going (called address).

To display a list of current Subscriber IDs (addresses), press[A] at the Connections and Routing Paths Menu (or [A], [D], [A] from the Main Menu).

To add or change a Subscriber ID, press [B] at the Connections and Routing Paths Menu. When prompted, enter a Subscriber ID of up to 15 digits. (ID conventions are described on page 8-21.)

N ode N ame=nodexyz

SVC Su bscrib er Maintenan ce
*	Su bscrib er I D	0100012345
A	Su bscrib er N ame	s ub1
B	Rou tin g Algorith m	0, R ound R obin
C	Sys tematic Redirection	N
D	Redirect on Bu sy	N
E	Redirect on Out of Order	N
F	Con nection Priority	0

GRou tin g Paths

HRedirection A ddresses

Op tion :

Figure 9-4 Typical SVC Subscriber Screen

[A],[D],[B]from Main Menu

Pressing [G] will display routing paths, which link the subscriber with one or more ports. Pressing [H] will display the addresses used for call redirection. (These addresses are valid only if Y is specified for one or more of items C, D, and E on the first screen.) Parameters for all three screens are described following Table 9-3.

9-14 SmartSwitch 1800 4. 0 User Guide, Rev 01