Cabletron Systems 9W111-08 manual Reset Switch

Page 15

The Reset Switch

The Reset Switch

The Reset switch is located on the front panel, under the top plastic tab, as shown in Figure 2-2.It serves two functions:

•Pressing the Reset switch twice within three seconds causes the processor to reset.

•Pressing and holding the switch on for three or more seconds causes the module to shutdown. Pressing and holding again for three seconds restarts the module.

SNMP management may be used to disable this switch to enhance module security.

Reset Switch

Figure 2-2. The Reset Switch

2-3

Image 15

Contents MMAC-Plus9W111-08 Eight Port WAN Router User’s Guide Page Page Vcci Notice FCC NoticeDOC Notice Page Contents Contents Introduction FeaturesManagement Information Base MIB Support Features Getting Help Related ManualsInstalling the MMAC-Plus Module Installing the MMAC-Plus Module Reset Switch Reset SwitchLocal Management Console Setting the FNB SwitchMenu Function Selection RJ-45 COM Port Operation W111-08 Block DiagramDC/DC Converter System Diagnostic ControllerFlexible Network Bus FNB System Management BusesCPU FNB InterfaceOperation Lanview LEDs Lanview LEDsLED Color State Description Functions of the WAN Status LEDs are listed in Table Lanview LEDs Safety ServiceSpeciﬁcations Environment Physical