Cabletron Systems 9W111-08 manual Setting the FNB Switch, Local Management Console

Page 16

Installing the MMAC-Plus Module

Setting the FNB Switch

The 9W111-08 module can attach to ether FNB-1 or FNB-2. Figure 2-3shows the location of the FNB switch, SW201. When this switch is up (toward the top of the module) the 9W111-08 attaches to FNB-2. When down, it attaches to FNB-1.

SW201

AUX and

COM Ports

Figure 2-3. Location of the FNB Switch

Local Management Console

Local Management is accessed by attaching a management console at the RJ-45 COM port of the 9W111-08. The console connection supports a Digital Equipment Corporation VT 320™ terminal or PC emulation of one of these terminals.

Table 2-1lists the setup requirements for the local management console. If your terminal is a Digital Equipment Corporation VT 320™ terminal, press F3 to access the Setup Directory. If you have a terminal emulation of the Digital Equipment terminals, refer to your equipment user manual for setup procedures.

2-4

Page 15 Page 17
Image 16
Page 15 Page 17
Contents MMAC-Plus9W111-08 Eight Port WAN Router User’s Guide Page Page FCC Notice Vcci NoticeDOC Notice Page Contents Contents Features IntroductionManagement Information Base MIB Support Features Related Manuals Getting HelpInstalling the MMAC-Plus Module Installing the MMAC-Plus Module Reset Switch Reset SwitchSetting the FNB Switch Local Management ConsoleMenu Function Selection RJ-45 COM Port W111-08 Block Diagram OperationSystem Diagnostic Controller Flexible Network Bus FNBSystem Management Buses DC/DC ConverterFNB Interface CPUOperation Lanview LEDs Lanview LEDsLED Color State Description Functions of the WAN Status LEDs are listed in Table Lanview LEDs Service SafetySpecifications Physical Environment
Top Page Image Contents