Cabletron Systems 9W111-08 manual RJ-45 COM Port

Page 18

Installing the MMAC-Plus Module

An RJ-45 connector provides a COM interface to the management terminal. Figure 2-4shows the pinouts.

Pin 1

RJ-45 COM PORT

RJ-45 TO 25 PIN	FEMALE - 25 Pin
CABLE	"D" Shell Connector

RECEIVE	4
TRANSMIT	1
SIGNAL GROUND	5
DATA SET READY	2
DATA TERMINAL READY	6

2 TRANSMIT

3 RECEIVE

7 SIGNAL GROUND

20 DATA TERMINAL READY

5 CLEAR TO SEND

COM PORT				LOCAL
RJ-45				MANAGEMENT
				CONSOLE
				RECEIVE
TRANSMIT	1		2	RECEIVE
RECEIVE	4		3	TRANSMIT
RECEIVE	4		3
SIGNAL GROUND	5		5	SIGNAL GROUND
DATA SET READY	2		7	READY TO SEND
DATA TERMINAL READY	6		8	CLEAR TO SEND

	RJ-45 TO 9 PIN	FEMALE - DB-9
		(9-Pin Connector)
	CABLE

Figure 2-4. Console Cable Pinouts

Connect the console to the module as follows:

1.Attach the male RJ-45 connector to the COM port of the 9W111-08.

2.Attach the female end (25-pin or 9-pin, as applicable) to the terminal.

Refer to the Cisco Systems documentation for the R4500 router, for information on conﬁguring this module.

2-6

Image 18

Contents MMAC-Plus9W111-08 Eight Port WAN Router User’s Guide Page Page FCC Notice Vcci NoticeDOC Notice Page Contents Contents Features IntroductionManagement Information Base MIB Support Features Related Manuals Getting HelpInstalling the MMAC-Plus Module Installing the MMAC-Plus Module Reset Switch Reset SwitchSetting the FNB Switch Local Management ConsoleMenu Function Selection RJ-45 COM Port W111-08 Block Diagram OperationSystem Management Buses System Diagnostic ControllerFlexible Network Bus FNB DC/DC ConverterFNB Interface CPUOperation Lanview LEDs Lanview LEDsLED Color State Description Functions of the WAN Status LEDs are listed in Table Lanview LEDs Safety ServiceSpeciﬁcations Physical Environment