CHAPTER 2
INSTALLATION
Only qualified personnel should install or service this unit.
To install the VHSIM-G02 you need the following items:
•Phillips screwdriver
•Antistatic wrist strap (shipped with the VHSIM-G02)
•Standoff screws (shipped with the VHSIM-G02)
Before using the VHSIM-G02 you should be familiar with the IEEE 802.3z, IEEE 802.3ab, and IEEE 802.3x specification. The network installation must meet the guidelines contained in the specification to ensure satisfactory performance.
2.1UNPACKING THE VHSIM-G02
The VHSIM-G02 and the host platform are sensitive to static discharges. Use an antistatic wrist strap and observe all static precautions during this procedure. Failure to do so could result in damage to the VHSIM-G02 or host platform.
Do not use sharp metal objects to open the VHSIM-G02’s antistatic bag. They can damage the VHSIM-G02.
Unpack the VHSIM-G02 as follows:
1.Remove the VHSIM-G02 from the shipping box. Leave the module in the antistatic bag until you are ready to install it.
2.Attach the antistatic wrist strap. Refer to the instructions on the antistatic wrist strap package.
3.After removing the VHSIM-G02 from the antistatic bag, visually inspect the device. If there is any sign of damage, contact Cabletron Systems immediately. Refer to Section 1.5 for instructions. Save the antistatic bag in the event the VHSIM-G02 must be reshipped.
VHSIM-G02 User’s Guide | 2-1 |
