Installing the VHSIM-G02
8.Press down firmly on the VHSIM-G02 until the connectors slide all the way onto the pins. Ensure that the standoffs on the interface module align with the standoff screw holes on the VHSIM-G02.
9.Secure the VHSIM-G02 to the module faceplate using the mounting screws saved in step 5.
10.Secure the VHSIM-G02 to the module standoffs using the standoff screws shipped with the VHSIM-G02.
11.Reinstall the interface module in the chassis.
12.Reattach the network cabling to the interface module.
2.2.2Installing the VHSIM-G02 in a Standalone Device
To install a VHSIM-G02 into a standalone device (e.g., 2H252-25R) that supports VHSIM technology, perform the following steps:
1.Power down the device and remove the power cord.
2.Note the ports that have cables attached to them. Write down the ports and label the cables to make it easier to reattach the network properly after the installation. Then disconnect the cables from the ports.
To install the VHSIM-G02 in a standalone device, the device must first be powered down. Ensure that you remove the power cord and ONLY the screws required to remove the chassis cover.
3.Attach the antistatic wrist strap (refer to the instructions outlined on the antistatic wrist strap package).
The VHSIM-G02 and the device are sensitive to static discharges. Use an antistatic wrist strap and observe all static precautions during this procedure. Failure to do so could result in damage to the VHSIM-G02 or device.
4.Remove the standalone device chassis cover. Refer to your specific standalone device documentation for instructions on removing the chassis cover.
VHSIM-G02 User’s Guide | 2-5 |