| |
| - Installation and Operating Instructions - |
|
|
|
|
INTRODUCTION | FCC REQUIREMENTS |
The remote control system can be operated thermo- statically or manually from the transmitter. The system operates on radio frequencies (RF) within a 20 foot range. Can be used with DSI, IPI or Standing Pilot systems.
This remote control kit has a hand held transmitter that can be used as a remote on/off or as a thermostat. The transmitter display shows the current room tempera- ture, target temperature, timer setting, on/off status, low battery indicator, current time and burner/valve op- eration. Electrical ratings for the receiver are: 110 VAC, 60 Hz.
If pertinent, see additional fireplace wiring diagrams on pages 8 to 10.
INSTALLATION PRECAUTIONS
This remote control kit is tested and safe when installed in accordance with this installation manual. Installa- tion of this kit MUST be done by a qualified service technician. It is the responsibility of the installer to read all instructions before starting installation and to follow these instructions carefully during installation. Modifi- cation of the remote control system or any of its com- ponents will void the warranty and may cause a fire hazard.
NOTE: The factory installed junction box in the gas fireplace must be wired with 110 VAC before installing this kit. See Installation Instructions sec- tion.
CAUTION: All wiring should be done by a qualified electrician and shall be in compliance with local codes and with the National Electric Code ANSI/NFPA No.
WARNING: DO NOT CONNECT
WARNING: CHANGES OR MODIFICATIONS TO THIS UNIT NOT EXPRESSLY APPROVED BY THE PARTY RESPONSIBLE FOR COMPLIANCE COULD VOID THE USER'S AUTHORITY TO OPERATE THE EQUIPMENT.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pur- suant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harm- ful interference in a residential installation. This equip- ment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guaran- tee that interference will not occur in a particular instal- lation.
Canadian Equipment Requirements
This digital apparatus does not exceed the (Class A/ Class B)* limits for radio noise emissions from digital apparatus set out in the Radio Interference Regulations of the Canadian Department of Communications. Le present appareil numerique n'emet pas de bruits radioelectriques depassant les limites applicables aux appareils numeriques (de la class A/de la class B)* prescrites dans le Reglement sur le brouillage radioelectrique edicte par le ministere des Communi- cations du Canada.
This device complies with
Hearth & Home Technologies Inc.
20802 Kensington Boulevard, Lakeville, MN 55044
1
