1.LOW - Battery power low. Replace batteries within two weeks.
2.TIMER - Indicates time remaining before system shuts off, when
3.MODE - Indicates operation MODE of system. ON indicates the system is on, either manually or thermostatically. THERMO indicates the system will automatically cycle ON/OFF, depending on programmed SET tem-
perature. OFF indicates the entire system is turned off.
4.SET - Indicates desired SET room temperature for THERMO operation.
5.FLAME - Indicates burner/valve operational.
6.CLOCK - Indicates the current time in AM/PM.
7.ROOM - Indicates CURRENT room temperature.
8.OF - Indicates degrees Fahrenheit (0C indicates degrees Celsius).
Figure 5. Transmitter LCD Display Screen
3 |
|
|
| THERMO | OFFON |
|
|
| 1 | |||||
|
|
|
| |||||||||||
7 |
|
|
| F | F |
|
|
|
| 4 | ||||
|
|
|
| |||||||||||
|
| |||||||||||||
|
|
|
| ROOM | SET |
| 8 | |||||||
|
|
|
|
|
|
|
|
| ||||||
6 |
|
|
| AM TIMER |
|
|
|
|
| 2 | ||||
|
|
|
| |||||||||||
|
| |||||||||||||
|
|
|
|
| FLAME |
|
| 5 | ||||||
|
|
|
|
|
|
| ||||||||
|
|
|
|
|
|
|
|
|
| |||||
MATCHING SECURITY CODES
It may be necessary to program the remote receiver to the security code of the transmitter upon initial use, if batteries are replaced, or if a replacement transmitter is purchased from your dealer. To program the remote receiver:
1.Set the slide button on the receiver to the REMOTE position.
2.Push the LEARN button (one beep will be heard) on the top of the remote receiver.
3.Then press the MODE button on the transmitter. Several beeps indicate the transmitter’s code has been programmed into the receiver. When an exist- ing receiver is matched to a new transmitter, the new security code will overwrite the old one. NOTE: When the LEARN button is depressed, “beeping” sounds should be heard. If no “beeping” is heard check to see that the receiver has
If you are unsuccessful in matching the security code on the first attempt, wait
OPERATING INSTRUCTIONS
To operate the system, press the MODE button (Fig- ure 5) on the transmitter to select the operational MODE desired.
•ON indicates the system is on, either manually, timed or thermostatically.
•THERMO indicates the system will automatically cycle ON/OFF, depending on programmed set tem- perature.
•OFF indicates the entire system is turned off.
Transmitter Settings
Flip open the plastic cover on the front of the transmit- ter to expose the “SET” buttons.
NOTE: Flashing numbers on the display indicate the system is waiting for input, such as using the UP and DOWN buttons to program a new setting. If no change is made to flashing digits within 15 seconds, the sys- tem will complete the procedure last programmed and reset the display to its normal state.
Setting the Clock
1.Press and hold the TIMER/TIME button on the trans- mitter for more than two seconds. The hour digit(s) will begin flashing (see Figure 5, Location #6).
2.Press the UP or DOWN button until the desired hour is displayed in AM or PM.
3.After setting the desired hour, press and release the TIMER/TIME button again to set the minutes; the minute digits will begin flashing.
4.Press the UP or DOWN button until the desired min- utes are displayed.
5.Press and hold the TIMER/TIME button again for more than two seconds. The time digits will cease flashing, indicating the clock has been successfully set. You may also press the SET button on the trans- mitter to stop the time digits from flashing and set the time.
4
