Cabletron Systems manual Installing the 9H531-17 and 9H532-17 Modules

Page 25

Installing the SmartSwitch 9000 Module

Jack for ESD wrist strap

Metal Back-Panel

Circuit Card

Card Guides

Warning:

Ensure that the circuit card is between the card guides.

Lock down the top and bottom plastic tabs at the same time, applying even pressure.

Figure 2-2. Installing the 9H531-17 and 9H532-17 Modules

2-7

Image 25

Contents 9033184-01 Page FCC Notice Cabletron SYSTEMS, INC Program License Agreement Iii Cabletron Systems Limited Program License Agreement Page Declaration of Conformity Contents Contents Introduction FeaturesIntroduction Auto-Negotiation Speed/Duplex Mode SmartTrunk Broadcast Suppression Switching Options Related Manuals Your email address Getting HelpUnpacking the Module Installing an Hsim or VhsimUser Accessible Components Prom Switch Function Description Using DIP Switch Installing the Module into the SmartSwitch 9000 Chassis Installing the 9H531-17 and 9H532-17 Modules Reset Switch Reset Switch10BASE-T Network Cabling Requirements100BASE-TX Network 100BASE-FX NetworkInstalling the SmartSwitch 9000 Module Technical Overview SmartSwitch ArchitectureTechnical Overview SMB-1 Bus System Management BusesSMB-10 Bus DC/DC Converter System Diagnostic ControllerINB Interface I960 CoreLanview LEDs LED Mode SwitchLED Color State Description Functions of the INB transmit LED are listed in Table Ethernet Receive LEDs Technical Speciﬁcations SpeciﬁcationsRegulatory Compliance ServicePhysical