D-Link DFL-200 warranty Set up built-in Dhcp server, Click Next Configure helper servers

The Setup Wizard (continued)

Step 4 - Set up built-in DHCP server

If you want to use the built-in DHCP Server in the DFL-200, choose Enable DHCP Server in this screen. You then need to specify a range of IP addresses to hand out to the DHCP clients.

This range is entered in the192.168.1.100-192.168.1.200

format “Start IP – Stop IP” i.e. 192.168.1.100 – 192.168.1.200. If you don’t want to use the built- in DHCP Server or confi gure

it later, choose Disable DHCP Server and click Next when done.

Click Next

Step 5 - Configure helper servers

NTP Servers - If enabled, specify which NTP Servers that should be used to syncronize the fi rewall time against.

Syslog Servers – If enabled, specify where the fi rewall should log, you can specify up to two Syslog receivers.

Click Next

10