English
Preparation
Using the remote control
IMPORTANT!
–Remove the protective plastic tab
before using the remote control.
–Always point the remote control directly towards IR area.
Notes for remote control:
–First select the source you wish to control by pressing one of the source select keys on the remote control (for example CD,TUNER).
–Then select the desired function (for example ÉÅ, 4 , ¢).
To replace the remote controls’
battery
1Press and hold 1 as indicated.
2Simultaneously, pull the battery tray at 4.
3Remove the old battery and put a new CR2025 battery in place.
4Put back the battery tray.
2
1
➠ | |
| 3 |
| CR |
| 202 |
L | 5 |
I |
|
T |
|
HIUM |
|
CAUTION!
–Remove the battery if it is exhausted or will not be used for a long time.
–Batteries contain chemical substances,
so they should be disposed of properly.
Setting the clock
After connecting MCM276R to the power supply, set the clock first.
1Press and hold
➜The display shows the set time
➜
2In the standby mode, press and hold DISPLAY/ CLOCK on the remote control
➜SET CLOCK scrolls on the display
➜24 HR or 12 HR appears for the initial clock setting. To select
● On the remote control, press VOLUME +/- once or more (or turn VOLUME on the set)
● On the remote control, press DISPLAY/ CLOCK to confirm
➜The hours digits start flashing
3Hold down or press VOLUME +/- repeatedly to set the hours (or turn VOLUME on the set)
4Press DISPLAY/CLOCK to confirm ➜ The minutes digits start flashing
5Hold down or press VOLUME +/- repeatedly to set the minutes (or turn VOLUME on the set)
6Press DISPLAY/CLOCK to confirm
– To exit without storing the clock setting press STOP 9
Helpful hints:
–The clock setting will be erased when the system is disconnected from the power supply.
–The set will exit from the clock setting mode if no button is pressed within 90 seconds.
/
16