Tuner
Tuning to radio stations
1Press SOURCE once or more to select TUNER (or TUNER on the remote control)
2Press TUNER on the remote control repeatedly to select your desired waveband, FM
or AM
➜ Display shows: 
, radio station frequency, waveband and if programmed, a preset number
/
3Press and hold 4 / ¢ until SEARCH appears
➜The radio automatically tunes to a station with sufficient reception. Display shows SEARCH during automatic tuning
➜FM: If a station is received in stereo, 
is shown
4Repeat step 3 if necessary until you find the desired station.
●To tune to a weak station, press 4 / ¢ briefly and repeatedly until you have found optimal reception.
Programming radio stations
You can store up to a total of 40 radio stations (FM and AM) in the memory, manually or automatically (Autostore).
1Press the ALBUM/ PRESET buttons once or more to select the preset number where programming should start.
Note:
– If no tuner preset number is selected, default is preset 1 and all your presets will be erased.
2Press and hold PROGRAM until AUTO appears
➜flashes
➜Available stations are programmed: FM stations followed by AM stations
➜After all stations are stored, the last preset station will then be played
Manual programming
1Tune to your desired station (see Tuning to radio stations)
2Press PROGRAM to activate programming
➜ flashes
3Press ALBUM/ PRESET to allocate a number from 1 to 40 to this station.
4Press PROGRAM to confirm
➜Display shows the preset number, waveband and the frequency of the preset station
5Repeat steps
●You can erase a preset station by storing another frequency in its place
To listen to a preset station
●Press the ALBUM/ PRESET buttons once or more until the desired preset station is displayed.
English
Autostore: Automatic programming
Automatic programming will start from preset 1 or a chosen preset number. From this preset number upwards, former programmed tuner stations will be erased.The set will only program stations which are not in the memory already.
23