Extron electronic 150xi, 130xi user manual RGB 134xi rear panel features

Page 13

RGB 134xi rear panel features

100-240 0.5A MAX.

 

R

G

B

 

 

GAIN/

SOG DDSP SERR SPARE

H

V

S

PEAK

100%

 

 

 

 

UNITY

 

 

 

 

50%

 

 

OUTPUT 1

 

50/60 Hz

 

 

 

R G B

HVS

OUTPUT 2

1

2

3

4

5

6

Figure 2-6 — RGB 134xi rear panel

1AC power input — standard IEC AC power connector (100 - 240VAC 50/60 Hz)

23-position gain/peak switch — unity*; gain with 50% peaking; and gain with 100% peaking

3DIP switches — 4 switches to control sync on green on output, Digital Display Sync Processing, serration pulse, and a 75-ohm input termination (refer to the section “Setting the DIP switches”)

4BNC output 1 — 6 BNC connectors to output RGsB, RGBS, and RGBHV

5Stereo audio output — 3.5 mm captive screw audio connector

6BNC output 2 — 6 BNC connectors to output RGsB, RGBS, and RGBHV

*Unity sets the output level equivalent to the input, with no added peaking.

If the signal cable between the interface and the display device is shorter than approximately 125 feet, and the level/peak switch is set to a setting other than Unity, the image may be overcompensated. If the edges of the image seem to exceed their boundaries, or if thin lines and sharp edges look thick and fuzzy, try changing the gain/ peak setting.

RGB 130xi , 134xi , 150xi Controls and Installation

2-6

Page 12 Page 14
Image 13
Page 12 Page 14
Contents Universal Interfaces RGB 130xi , 134xiPrecautions Table of Contents RGB 130xi , 134xi One Introduction Two RGB 150xi front panel features Controls and InstallationRGB 150xi rear panel RGB 150xi rear panel featuresRGB 130xi front panel features Controls and Installation, cont’dRGB 130xi rear panel RGB 130xi rear panel featuresRGB 134xi front panel RGB 134xi front panel featuresRGB 134xi rear panel RGB 134xi rear panel featuresEasy setup procedure Attaching the under desk brackets Mounting the interfaceAttaching the through desk brackets Front Cabling13 RGB 150xi installation Unbalanced audio Connecting audio outputBalanced audio Appropriate end of each switch Setting the DIP switchesOhm input termination 15 Opening the interface cover Setting internal jumpersPins 2 and 3 connected Jumpers perform the following functions RGB 130xi , 134xi , 150xi Controls and Installation AAppendix Video throughput Specifications RGB 130xi, 134xi Video inputVideo output SyncAudio throughput Audio inputAudio output GeneralAppendix, cont’d Accessories and Part Numbers BNC cables RGB 130 xi , 134 xi , 150 xi Appendix RGB 130xi, 134xi, 150xi Appendix RGB 130 xi , 134 xi , 150 xi Appendix RGB 130xi, 134xi, 150xi Appendix FCC Class a Notice Extron’s Warranty Extron ELECTRONICS, Asia
Top Page Image Contents