Extron electronic 130xi, 134xi user manual RGB 150xi installation

Controls and Installation, cont’d

Front

PC Computer

AUDIO INPUT

UNIVERSAL	INTERFACE W 150 xi
H.
	RGB
SHIFT	/ADSP
	MIN/MAX

Rear

SOGOUT DDSP SERR SPARE OUTPUT

Power Audio

or

MonitorProjector

Figure 2-13 — RGB 150xi installation

2.Connect the interface cable marked “Video input” to the computer’s video output (where the monitor was originally connected).

3.For audio connections, refer to the following “Connecting Audio” section for important information concerning unbalanced and balanced audio. Connect audio input to the interface’s front panel audio input jack. Connect audio output to the captive screw connector on the interface’s rear panel.

4.Use BNC cables to attach the interface to a projector or other display device.

R	G	B	RGsB – If coax cables are connected and
			terminated (75 ohms) to the red, green, and
H	V	S
			blue channels only, and the SOG OUT switch
RGsB
			is set to on (see page 2-14), the output will be
			sync on green.
R	G	B	RGBS – If the S (composite sync) cable is
H	V	S
			connected, the output will be composite sync.

RGBS

RGB

HV S

RGBHV

RGBHV – If both the H & V cables are connected, the sync output is separate horizontal and vertical.

2-11 RGB 130xi , 134xi , 150xi Controls and Installation