Extron electronic ECP 1000 user manual Square wipe effects

Page 11

Operation, cont’d

Figure 3-11 — Square wipe effects

Applying a wipe

To apply a wipe, do the following:

1.Press the effect button that is programmed to perform the wipe you want.

2.If this is the first time any effect has been selected since the ECP 1000 was first installed or since a system reset was performed, the number of screen selection buttons that light will be based on the type of wipe that was selected. For example, if you press a two-screen effect button, screen selection buttons 1 and 2 light.

If this is not the first time any effect has been selected since the ECP 1000 was first installed or since a system reset was performed, the screen selection buttons that were selected the last time an effect was applied will light.

If you want to deselect a screen that is lit and select a screen that is not lit, press the button for the screen that you want to turn off. For example, if buttons 1 and 2 are lit, and you want to apply the effect to screens 1 and 3 instead, press the 2 button. The 2 button light turns off, and the 3 button light turns on.

3.If you want to use a duration other than the default duration, turn the Adjust knob until the desired duration appears on the LCD menu’s default screen.

4.If desired, press the Soft Edge button.

5.Do one of the following.

•Press the Take button. The wiping switch begins immediately and is finished in the time specified by the duration. During the wipe, the LCD displays a percentage count (1 – 100) as the effect is completed (figure 3-12). The former preview image is now the new program image.

28%

3.0 SEC

Figure 3-12 — Wipe percentage count

•Move the T-bar control. The wiping switch takes place until you move the T-bar to the opposite end point of the t-bar slot. Or, you could stop moving the T-bar and press the Take button, in which case the switch is completed during the remaining duration time. Regardless of the method, the LCD displays the percentage count as described in the previous paragraph.

During a wipe, you can reverse the direction of the wipe (in effect, “unwipe” the program image) by reversing the direction of the T-bar control. This is true until the T-bar reaches the end point of the T-bar slot, in which case the effect is considered completed.

3-10 ECP 1000 • Operation

ECP 1000 • Operation 3-11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Event Control Panel ECPTable of Contents Introduction Table of Contents, cont’dOne Introductionroduction, cont’d InstallationFeatures TwoInstallation Installationtal ation, cont’d Rear Panel FeaturesOperation Installation, cont’dThree Operationration, cont’d Top Panel Controls Power-upChanging the backlight intensity Using the MenusPerforming a system reset Operation, cont’dApplying a title Applying a SwitchApplying a dissolve Applying a cutStandard wipe transitions Wipes11 Square wipe effects Control Software for Windows FourStarting the Software Installing the SoftwareControlSoftwareforforWindows,cont’d Control Software for Windows, cont’d AAppendixReference Information Installing a firmware update ReferencerenceInformation,cont’d Maintenance and UpgradesCleaning the fan filter General SpecificationsReference Information, cont’d Replacing keycap labelsMtbf Part NumbersPrecautions
Top Page Image Contents