Extron electronic ISS 408 manual Vertical detail filter RGB and component video inputs

Programmer’s Guide, cont’d

Command/response table for SIS commands (cont’d)

Command	ASCII Command	Response	Additional description
	(host to switcher)	(switcher to host)

Vertical detail filter (RGB and component video inputs)

The vertical detail filter is available only for RGB and component video inputs.

The X2 value specified is the output to which the filtered input is switched.

The command (d) is case sensitive.

Set a specific filter value

Increment filter value

Decrement filter value

View the vertical filter value

X2

X2

X2

X2

*X18 d

+d

-d d

X2	Dvz	X18	Set the vertical detail level.
	Dvz		Increase the vertical detail level.
X2		X18
	Dvz		Decrease the vertical detail level.
X2		X18
			Show the vertical detail level.
		X18

Detail filter (S-video and composite video inputs)

Composite and S-video inputs support a single detail filter only, rather than separate horizontal and vertical filters. To apply a detail filter to the scaled output when the input is composite video or S-video, use the same command as the horizontal filter (D) with the X18 variable.

The X2 value specified is the output to which the filtered input is switched.

Set a specific filter value

Increment filter value

Decrement filter value

View the vertical filter value

X2

X2

X2

X2

*X18 D

+D

-D

D

X2	Dvz	X18	Set the detail filter level.
	Dvz		Increase the detail filter level.
X2		X18
	Dvz		Decrease the detail filter level.
X2		X18
			Show the detail filter level.
		X18

Auto Memories

Auto memories on	1M	Aut	X3	Set the ISS to apply auto
				memories settings to all selected
				inputs.
Auto memories off	0M	Aut		Set the ISS to not apply auto
			X3
				memories settings.

View auto memories status M

X3	Auto memories is
	for all inputs.

X3

(on or off)

User presets

The X2

Save user preset

Recall user preset

value specified is the output to which the input with the associated user preset is switched.

*

,

Spr

•

Command code is comma. Save

X2

X19

X2

X19

the

outputs settings as preset

X2

.

X19

*

.

Rpr

•

Command code is period. Recall

X2

X19

X2

X19

preset

settings for

output.

X19

X2

Freeze

Enable

Disable

View the freeze status Example:

X2	*1F		X2	Frz1	Output a “frozen” video image.
	*0F			Frz0	Turn off freeze (output motion
X2			X2
					video).
	F				Show the freeze status.
X2			X3
	F	0			Freeze mode is off.
X2

Test pattern

Select test pattern for an output

X21	*	X22	J	Tst	X21	*	X22	Select a test pattern for the
								output(s).

X21

View test pattern	J
Example:	j

X21	*	X22	Show the test pattern.
3*002			Crosshatch test pattern was
			selected for both outputs.

4-12 ISS 408 Integration Seamless Switcher • Programmer’s Guide