Extron electronic MLS 103 V, MLS 102 VGA, MLS 103 SV, MLS 100 A user manual Table of Contents

Page 4
CONTROL/

Quick Start Guide — MLS 100 Series, cont’d

To connect an MLC 206 or a third party control system, see the diagram below, and see page 2-8for details.

POWER

MLS100Series

 

Switcher

A B

Control/Power

Port

NOTE You must connect a ground wire between the MLC and MLS.

+12VDC input Ground ( )

Table of Contents

Chapter 1 • Introduction

1-1

About this Manual

1-2

About the MLS 100 Series Switchers

1-2

Features

1-2

Chapter 2 • Installation

2-1

UL/Safety Requirements

2-2

External

Power Supply

(12VDC, 1A max.)

+12VDC

Ground ( )

BReceive (Rx) Transmit (Tx) B

A Transmit (Tx) Receive (Rx) A

NOTE If you use cable that has a drain wire, tie the drain wire to ground at both ends.

Mounting the Switchers

2-2

Tabletop use

2-2

Rack mounting

2-2

Furniture or projector mounting

2-4

For furniture mounting

2-4

 

MLC 206's

 

MLS/Power

Step 4

Port

A B

Connect power cords and turn the equipment on. MLS / Power

Step 5

Test the system: select an input from the front panel buttons or via the control software; observe the display and listen to

the audio output. If you use the MediaLink Control Software, set the volume control in the Controller (MLC) Config section to “Switcher”, as shown at right. Make any needed cabling corrections.

To avoid damage to your hearing, the Aux/Mix input and the selectable audio inputs’ levels and output volume should be set as low as possible before you test the sound system.

Step 6

Adjust the Aux/Mix level: turn the front panel potentiometer while listening to the audio

output. See page 3-3.

Step 7

Set up the switcher. In

the Switcher (MLS) Config part of the MediaLink Control Software, set the per- input audio adjust- ments, RGB delay period (MLS 102 VGA), and the output volume. See pages 4-8 to 4-10.

For projector mounting

2-4

Rear Panel Features and Cabling

2-5

Video connections

2-5

Audio connections

2-6

Control and power connections

2-8

Setting Up Optimal Audio Gain

2-9

Setup via the MediaLink Control Software

2-10

Application Diagrams

2-11

Chapter 3 • Operation

3-1

Front Panel Features and Operation

3-2

Executive mode — enabling and disabling

 

front panel buttons

3-3

Troubleshooting

3-4

Chapter 4 • Serial Communication

4-1

RS-232 Programmer’s Guide

4-2

Host-to-MLS communications

4-2

MLS-initiated messages

4-2

Error responses

4-3

Using the command/response tables

4-3

Command/response table for SIS commands

4-4

Command/response table for

 

special function SIS commands

4-6

Control Software for Windows®

4-7

Installing the software

4-7

QS-2 MLS 100 Series • Quick Start Guide

MediaLink VersaTools Switchers • Table of Contents

i

Image 4
Contents MediaLink VersaTools Switchers User’s ManualExtron’s Warranty PrecautionsFCC Class a Notice Quick Start Guide MLS 100 Series Attach the cables. See the instructions beginning onTable of Contents MediaLink VersaTools Switchers Table of Contents, cont’dOne IntroductionTwo InstallationIntroduction Installation UL/Safety RequirementsMounting the Switchers Tabletop useInstallation, cont’d Rear Panel Features and CablingFurniture or projector mounting Video connectionsAudio connections Aux/Mix Mono audio input all models -The Aux/MixControl and power connections Setting Up Optimal Audio GainTypical Audio Levels for Various Equipment Types Setup via the MediaLink Control Software Application DiagramsGain and Attenuation Settings for MLS 100 Series Switchers Chapter Three OperationFront Panel Features and Operation Executive mode enabling and disabling front panel buttonsMediaLink VersaTools Switchers Operation OperationOperation, cont’d Troubleshooting Serial Communication 4ChapterOperation, cont’d MLC/RS-232 Power port pin assignments Serial CommunicationRS-232 Programmer’s Guide Host-to-MLS communicationsCommand/response table for SIS commands Serial Communication, cont’dCommand/response table for special function SIS commands Installing the softwareUsing the control program Control Software for WindowsUser Mode For stand-alone MLS 100 Series switchersSpecial features For MLS 100 Series switchers controlled by an MLCEmulation mode Saving and restoring configurationsSwitcher MLS Config Specifications, Part Numbers Accessories Using the help programAAppendix a Key to file namesSpecifications, Part Numbers, and Accessories Specifications, Part Numbers, Accessories, cont’d Control/remote switcherAudio output GeneralAccessories CablesAdapters Plenum Comm-link cable Part number
Related manuals
Manual 27 pages 43.28 Kb

MLS 100 A, MLS 103 SV, MLS 102 VGA, MLS 103 V specifications

Extron Electronics is renowned for its innovative and high-quality AV solutions, and the MLS series, including the MLS 102 VGA, MLS 100 A, MLS 103 SV, and MLS 103 V, exemplifies the company's commitment to excellence in audio-visual integration. These MediaLink Switchers are designed to simplify the management of multiple audio and video sources in classrooms and conference rooms, providing seamless integration and user-friendly operation.

The MLS 102 VGA model focuses on VGA signals, making it a reliable choice for installations that primarily use legacy video sources. It features a simple interface with push-button controls, enabling users to easily switch between two video sources with a single VGA output. This model is ideal for educational environments where older laptops and PCs are still in use.

The MLS 100 A model adds audio capabilities to the mix, offering audio switching along with video. This switcher supports stereo audio signals, allowing educators to present multimedia content effectively. The MLS 100 A simplifies the setup for instructors, enabling them to connect different media sources without complicated wiring or extensive technical knowledge.

The MLS 103 SV and MLS 103 V models elevate functionality with their multi-format switching capabilities. The MLS 103 SV supports both VGA video and stereo audio, while the MLS 103 V is solely focused on video. Both models provide a more comprehensive solution for modern AV requirements. The MLS 103 series employs advanced signal processing technology, ensuring high performance across multiple resolutions and formats.

Additionally, the MLS 103 series incorporates features such as EDID management, which automatically configures the video output to ensure compatibility with a variety of display devices. This eliminates the need for users to worry about the technicalities, enabling a smooth, hassle-free experience.

Scalability is another key characteristic of the MLS series. These devices can be seamlessly integrated with other Extron products, allowing for an expandable AV infrastructure that meets the growing demands of technology in educational and corporate environments.

Durable construction, easy installation, and operation make the MLS series a preferred choice among AV professionals. Whether for a small meeting room or a large lecture hall, Extron's MLS 102 VGA, MLS 100 A, MLS 103 SV, and MLS 103 V models deliver flexibility, reliability, and superior performance, enhancing any audio-visual presentation.