Extron electronic MTP manual Three, Operation

Page 17

Installation, cont’d

10Captive screw audio connector (MTP R SV A, MTP R AV) — Connect a balanced or unbalanced audio device, such as an audio amplifier to this 3.5 mm, 5-pole captive screw connector. See figure 2-21 to properly wire the output connector.

	Tip	Tip	L
	NO GROUND HERE.	Ring	L
	NO GROUND HERE.	Ring
	Sleeve(s)	Sleeve(s)
	Tip	Tip	R
	NO GROUND HERE.	Ring	R
	NO GROUND HERE.	Ring

Do not tin the wires!		Unbalanced Stereo Output Balanced Stereo Output
Figure 2-21 — Captive screw connector wiring for
audio output
		Some receivers do not have audio connections.
		Some receivers do not have audio connections.
				Connect the sleeve to ground (Gnd). Connecting
	CAUTION			Connect the sleeve to ground (Gnd). Connecting
				the sleeve to a negative (-) terminal will damage the
				audio output circuits.
				The length of the exposed (stripped) portion of the
	CAUTION			The length of the exposed (stripped) portion of the
				copper wires is important. The ideal length is
				3/16" (5 mm). Longer bare wires can short
				together. Shorter bare wires are not as secure in the
				direct insertion connectors and could be pulled out.

11RCA audio connectors (RCA models) — Connect a stereo audio device to these L(eft) and R(ight) RCA connectors.

VersaTools® MTP Series

Chapter3Three

Operation

Front Panel Features

Troubleshooting — Skew Delay Compensation

2-20 VersaTools® MTP Series • Installation

Image 17

Contents VersaTools MTP Series Extron’s Warranty PrecautionsFCC Class a Notice Table of Contents One Table of Contents, cont’dIntroduction VersaTools MTP SeriesAbout the MTP Transmitters and Receivers IntroductionTP Cable Advantages Transmission DistanceIntroduction, cont’d InstallationTwo Setting the jumpers on non AAP models InstallationSignal Jumpers for Generational Compatibility Shift the jumper to the alternate location Installation, cont’dCover to the MTP figure Setting the jumpers on AAP transmittersRack mounting all except AAP models Installation, cont’d Mounting OptionsTabletop use all except AAP models Frame mounting AAP models Furniture or projector mounting all except AAP modelsTransmitter input connections Panel Features and ConnectionsMTP Receivers Transmitter/receiver throughput connectionsTP cable termination Power connection all modelsImportant. The ideal length is 3/16 5 mm Receiver output connectionsOperation ThreeTroubleshooting Skew Delay Compensation Front Panel FeaturesAAppendix a Reference InformationSpecifications Specifications, Part Numbers, and AccessoriesGeneral Specifications, Part Numbers, Accessories, cont’dAudio output audio models A, AV SVA models only Accessories AAP accessoriesCables/connectors Skew compensation solutionsSpecifications, Part Numbers, Accessories, cont’d